Troubleshooting¶
The YUMI logo shows, then no image¶
The logo is drawn by the screen itself: it only proves the screen has power, not that the computer sees it.
- Unplug the USB-C cable at both ends, wait a few seconds, plug it back. This fixes most cases.
- Use the USB-C to USB-C cable from the box. A charge-only USB-C cable gives power but no image.
- Try another USB-C port of the computer. The port must output video (USB-C with DisplayPort, or Thunderbolt).
- Check that the cable is in the full-featured USB-C port of the screen, not the power-only one.
- With HDMI, check that the screen is powered through USB-C (see Connecting the screen).
On a Mac, the screen must appear as YUMi-SF15TPEN in System Settings > Displays.
Mac: check from the Terminal
If neither command shows the screen, the Mac has no data link with it: it is a cable or port problem, not a software one.No logo, screen stays black¶
- The screen gets no power. Try another cable or port, or connect a USB-C charger to the other USB-C port.
The screen turns off or restarts¶
- The computer's port may not supply enough power. Connect a USB-C charger to the other USB-C port.
Image but no touch¶
- Use the USB-C to USB-C cable: it carries touch as well as image.
- With HDMI, touch needs a USB link to the same computer (see Connecting the screen).
- Unplug and replug the USB-C cable.
No pressure, or stylus not detected¶
- On a Mac, open Yumi Desktop: without it the screen stays in mouse mode, without pressure. See Yumi Desktop.
- On a Mac, check the Accessibility, Input monitoring and Event posting permissions of Yumi Desktop.
- Check that you use the YUMI active stylus. A passive stylus has no pressure.
Still not working¶
Note your serial number (rear label) and the computer model and system version, then contact the seller you bought the screen from.